VTech Kidizoom Smartwatch DX2 Wristband Replacement

Written By: Sydney
  • Comments: 2
VTech Kidizoom Smartwatch DX2 Wristband Replacement

Difficulty

Very easy

Steps

4

Time Required

3 - 4 minutes

Introduction

If your wristband has visible damage, is worn, torn or broken the following guide will help you repair your problem.

  1. nZhU6cXUXy1EceoX

    • Begin by placing the watch on its side.

  2. PcqBNCQBUpmRdRy3

    • Next, use the flat end of the spudger to wedge between the small-headed pin (located on the band closest to the watch) to pull the pin up through the other side.

  3. kN1WNCKjAC43SnOy

    • Pull the pin out, however not fully, feeling slight resistance is normal.

  4. tpGJBeSx5RXrhvIw

    • Finally, pull the wristband off. Repeat on the opposite side of the watch if necessary.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Author

Sydney

Member since: 25/10/18

344 Reputation

2 comments

My Vtech DX2 had a split pin. One side of the pin was the long side and the other very very short. So look out for that. Thanks for this tutorial, was very helpful.

Ryan Laurel -

Where can I buy a replacement wristband for dx2? Thanks

Ari -